|
System III ApplicatorBest of the Past... ...Built for Today.
The System III Applicator helps you meet the evolving demands of high mix/low volume job environment with a separated crimp and feed for optimized operation of both, an iButton data module to store and transmit terminal and applicator information and a feed thats independent of ram stroke for more precise feeding requirements. Built-In Intelligence
A Separate Feed, a Better Feed
New Ram Cross-Section
Crimp Height Adjustment
More Information
Contact Us Today!
|
The iButton data module built into the System III Applicator stores the personality of the applicator, its identity, and the terminals it can crimp. It also contains all crimping parameters for system confirmation. Data is transmitted through a simple contact for processing in the terminator and the system computer.
In the System III Applicator, the feed function is completely independent of the ram stroke. The limitations of the mechanical linkage are gone. So is manual adjustment every time terminal spacing varies or feed errors arise. And so are the errors that rob machine uptime and reduce productivity. 
Precise positioning of the crimper over the anvil is essential. Misalignment could increase reject rate or even cause jams. A new circular ram cross-section, rather than the traditional square shape, provides tighter clearances, maintaining more precise, predictable tooling alignment.
Manual crimp height adjustment has been eliminated. All crimp height adjustment, both coarse and fine steps, takes place in the AMP-O-LECTRIC ST III Terminator, completely under program control. In fact, there is no wire height disk on the applicator, only the insulation disk. The result is faster setup, with no error-prone manual adjustment.